It will not however see other Mods mobs, for those, you need the Mob Spawner blocks.įirst choose a corner of the Orc Hill Fort and build a dirt column, 1 block wide, higher than the tallest possible tree heights in the biomes you want the fort to spawn in. – Yes – Any AW or Vanilla mob or creature can be scanned by the scanner and will appear when the structure spawns. Ok, so we are going to scan this model of an Orc Hill fort, complete with its Orc NPC’s that have been placed by hand, not by using spawner blocks. Heres how my Inventory looks when preparing for scanning or building.įrom right to left in the inventory bar – Build Helper deletion wand, Build Helper creation wand, instant water block, instant lava block, Instant Blocks command wand, AW Structure Builder, AW Mob Spawner, AW Structure Scanner, A dirt block. If you are using Monsters Spawners, place the monster spawner block in your inventory too. Go to the AW Creative Tab and take the structure scanner and structure builder orders and place them in your inventory. Ok, so you have your floating structure, how do you scan it?įirst, you need to be in Creative Mode. These mobs can be any mobs from any mods you have loaded. If you also use AW Mob Spawner blocks in the structure, and set them up before you scan the building, when the structure spawns, and players come within range, the mob spawner will spawn the mobs you set for it. Once you have created your structure, you may want to use the AW scanner to scan the building, and then have it appear in the biomes you want, using the AW World Gen system. The AW mod itself comes with instant blocks and tools, but they may be cumbersome to use. Instant Blocks has a lot of structures itself, but also instant water blocks for filling oats and lakes etc. The Build Helper has simple to use point and click wands that allow multiple block generation or deletion and using them speeds construction enormously. Two essential tools to use when structure building are: Prefer the use of “Builder Worlds” – flat worlds with no structure gen turned on, in which you place all the structures.
When you build a structure, build it in the air, floating by itself, or use MCEdit to cut out the structure and place it there after you’ve built it, this makes scanning much easier, and you can easily place and see the limits and boundaries of basements and dungeons that are part of the structure. How to use the 1.7.10 AW Structure Scanner First, a few building tips
0 kommentar(er)
